JUMO

Actuator

Automatisierung

Flow

Humidity & CO2

Level

Liquid analysis

Pressure

Product list A-Z

Product selector

Temperature

JUMO Wtrans E01

The Wtrans E01 measuring probe is used in combination with a Wtrans receiver for recording measured values using digital sensors for humidity, temperature, and CO2. Other measurands can be derived from the determined measured values.

JUMO Wtrans p

The product acquires the pressure of liquid or gaseous media in combination with a Wtrans receiver. The measured values on the receiver are provided in a digital format and as an electrical signal. The product is used in instances where laying a cable would be too demanding.

JUMO Wtrans receiver

The Wtrans receiver T01, in combination with suitable Wtrans transmitters, is used for the mobile or stationary measurement of the following physical measurands: temperature, pressure, and humidity. The wireless sensor technology also works in a harsh industrial environment.

JUMO Wtrans T

The thermometer acquires temperatures in the operating range from -30 to +260 °C or -200 to +600 °C. This measured value is transferred wirelessly to the receiver of the Wtrans measuring system. This makes it ideal for mobile or stationary temperature measurement without any wiring work.

JUMO ZELOS C01 LS

The capacitive level switch identifies the level of liquids and solids. It can also be used in pressurized tanks or pipes. Typically, the level switch is used in industrial environments for applications with requirements for overflow and dry-run protection or for media detection (such as sludge in separation processes).

JUMOL Panel-mounting Thermostats

Panel-mounting thermostats monitor thermal processes. In fault condition, the protection temperature limiter STB sets the system being monitoredto a safe operational state.

Laboratory pH combination electrodes

The electrode acquires the pH value of water and aqueous-based media. It is used in general laboratory applications.

Laboratory redox combination electrodes

The electrode acquires the redox potential of water and aqueous-based media. It is mainly used in general laboratory applications.

Level and temperature probes

This product is for monitoring the level and temperature of engine oil and gearbox oil as well as for supporting vehicle diagnosis in modern commercial vehicles, construction machines, and agricultural machines.

Lines, connectors, and sockets

Shielded lines must be used for the connection of pH and redox electrodes, compensation thermometers, and conductivity measuring cells. The lines can be equipped with a corresponding connector or corresponding socket on the sensor as well as on the device.

Logoprint 084, LMv-44/4

Measuring value printer with galvanically isolated measuring modules

Logoprint 140, LP6v-44/4

Installation housing according to DIN 43831, front frame dimension 144 × 144 mm